Okey, who likes music or to the drums. Previously I will give information (name is also burgers information so full of information :)) for the memula drum. It was not only the guitar should be in setting the tone. However, the drum will also need the correct settings in order to blow produced a beautiful tone. Actually I knew little of drum hehehe .... but about setting the download settings in the drum do not also underestimate yes. in this post I will explain how to set perangkt steady drum that sounds when hit. Previous friends must know the parts of the drum itself.
-The First is TOM DRUM (not Tom and Jerry the mouse yes but TOM drum)
Tom drum is also divided into two categories the first Rack Tom (tom drum hanging position) and Floor Tom (tom drum which has a leg and placed directly on the floor).
This picture if you do not know the name tom drum :)
Okey for setting tom drum you should know the name Batter Head. Batter head is a nut that is at the top of the tom drum that is useful to tighten and loosen the skin tom drum top. You must set the appropriate sound when it is too loud, the tone terdemar will feel restrained. However, if too loose, the tone is heard to be broken so the best ya think you pass.
Then if that was the top of the head that's called better bottom called resonant head (nut bottom to resonate sound). Make tension resonant head slightly lower or equal to the batter head. Make it produces sustain sufficient.
The second is the snare drum
Snare drum also has several parts:
-Batter Head
Like on the tom drum, snare drum also has a head batter, batter Starting with the head (upper skin). Remove the batter head of the shell (drum body). Flex head by pressing the edges to the inside (do not be afraid broken, batter head is very strong). After that, put the head on the shells. Put the rim (iron ring), and turn the tension rod (bolt) using a hand with crossed sequence. For example, the screw 1 and then screw just opposite and so on. Play all bolts with cross sequence, until it can no longer be rotated by hand. After that, turn the drum key (key bolts player), turn half round all the bolts crosswise. Press the center of the head using two hands (do not be afraid broken), the emphasis is useful for the holder head does not change. At the edge of the head (near the bolt) with a drum key, and keep all parts sound the same. Do a few rounds until you get the desired sound.
-Snare Side Head (leather bottom).
Do it the same way, but be careful with this because it is very thin head (do not do stretching and pressure). Create tension head is slightly higher than the batter's head, so that it can respond with a good wire snare.
-Snare Wire (wire snare that produce sound under the snare)
In order to produce a good snare sound, create tension snare wire so that it can capture the sound blows most slowly though. Do not set too taut wire, because the snare sound will be muffled.
-The Third BASS DRUM
For setting up the bass drum that sounds a steady pace I was doing this:
-Open All head, then enter ± 3 cm thick foam, with a width equal to the length of the bass drum, so that it touches the head. For the length, make ± 1/2 of the circumference of the bass drum. Can also use a pillow or rolled-up towel and then touched to the bass drum head.
-Then Pairs batter head (skin beaten beater pedal). Turn the screw until the wrinkles disappear (rotate the order of crossing).
-After The post resonant head (front leather bass). Set the same tension with headnya batter.
-To Produce drum sounds good, it's good drumhead (skin / membrane) is replaced with a drumhead nice too.
No comments:
Post a Comment